 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| MC33174 - MC35174 LOW POWER QUAD BIPOLAR OPERATIONAL AMPLIFIERS .GOOD .SI .WI .LOWLEVELOUTPUTVOLTAGECLOSETO .PI .ESDPROTECTI VCC-: 100mV TYPICAL N TO PIN COMPATIBLE WITH STANDARD QUAD OP AMPs ON CONSUMPTION/SPEED RATIO : ONLY 200A/Amp FOR 2.1MHz, 2V/s NGLE (OR DUAL) SUPPLY OPERATION FROM +4V TO +44V (2V TO 22V) DE INPUT COMMON MODE VOLTAGE RANGE INCLUDING VCC- N DIP14 (Plastic Package) D SO14 (Plastic Micropackage) DESCRIPTION The MC33174 series are quad bipolar operational amplifiers offering both low consumption (200A/Amp) and good speed (2.1MHz, 2V/s). Moreover the Input Common Mode Range extends down to the lower supply rail, allowing single supply operation from +4V to +44V. PIN CONNECTIONS (top view) ORDER CODES Part Number MC33174 MC35174 Temperature Range -40 C, +105 C -55 C, +125 C o o o o Package N * * D * * Example: MC33174N Output 1 1 Inverting Input 1 2 Non-inverting Input 1 3 VCC + 4 Non-inverting Input 2 5 Inverting Input 2 6 Output 2 7 + + + + 14 Output 4 13 Inverting Input 4 12 Non-inverting Input 4 11 VCC 10 Non-inverting Input 3 9 8 Inverting Input 3 Output 3 December 1997 1/5 MC33174 - 35174 SCHEMATIC DIAGRAM (for 1/4 MC33174) V CC + R4 R5 R6 T7 T1 T8 T9 R7 R3 T15 T10 R8 T11 T12 T13 T25 T16 T17 R13 Input + T24 T26 T6 Input - T14 C T5 T2 T13 T21 T22 R12 R14 Output T19 T3 T4 R2 R1 R9 R10 R11 T20 T27 T29 T23 R15 T28 T30 T31 V CC - ABSOLUTE MAXIMUM RATINGS Symbol VCC Vid Vi Toper Tj Tstg Supply Voltage Differential Input Voltage Input Voltage Output Short Circuit Duration Operating Temperature Range Junction Temperature Storage Temperature MC33174 MC35174 Parameter Value 22 (Note 1) (Note 1) Indefinite -40 to 105 -55 to 125 150 -65 to 150 Unit V V V s o C C C o o Note 1: Ei ther or both i nput voltages must not exceed the magnitude of VCC . OPERATING CONDITIONS Symbol VCC Supply Voltage Range Parameter Value 2 to 22 Unit V 2/5 MC33174 - MC35174 ELECTRICAL CHARACTERISTICS VCC+ = +15V, VCC- = -15V, RL connected to Ground, Tamb = 25oC (unless otherwise specified) Symbol Vio Parameter Input Offset Voltage + VCC = +15V, VCC = -15V, Vic = 0V + VCC = 5V, VCC = 0V, Vic = 0V, Vo = 1.4V VCC+ = +15V, VCC- = -15V, Vic = 0V, Tmin. Tamb Tmax. Input Offset Voltage Drift Input Offset Current (Vic = 0V) Tmin. Tamb Tmax. Input Bias Current (Vic = 0V) Tmin. Tamb Tmax. Large Signal Voltage Gain (RL = 10k, VO = 10V) Tmin. Tamb Tmax. High Level Output Voltage VCC+ = 5V, VCC- = 0V, RL = 10k + VCC = +15V, VCC = -15V, R L = 10k VCC+ = +15V, VCC- = -15V, R L = 10k, Tmin. Tamb Tmax. Low Level Output Voltage VCC+ = 5V, VCC- = 0V, R L = 10k + VCC = +15V, VCC = -15V, R L = 10k VCC+ = +15V, VCC- = -15V, R L = 10k, Tmin. Tamb Tmax. Output Short Circuit Current (Vid = 1V, VO = 0V) Source Sink Input Common Mode Voltage Range Tmin. Tamb Tmax. CMR SVR ICC Common Mode Rejection Ratio (Vi = Vicm min.) Supply Voltage Rejection Ratio (VCC = 5 to 15V) Supply Current (per amplifier) + VCC = 5V, VCC- = 0V, no load VCC+ = +15V, VCC- = -15V, no load VCC+ = +15V, VCC- = -15V, no load, Tmin. Tamb Tmax. Slew Rate (Vi = 10V, RL = 10k, CL = 100pF) Gain Bandwidth Product (R L = 10k, CL = 100pF, f = 100kHz) Phase Margin (RL = 10k, C L = 100pF) Equivalent Input Noise Voltage (f = 1kHz) Total Harmonic Distortion Channel Separation 1.6 1.4 3 15 VCC to + (VCC - 1.8) VCC- to + (VCC - 2.2) 80 80 100 100 200 220 2 2.1 45 29 0.05 120 250 250 300 V/s MHz Degrees nV Hz % dB - Min. Typ. 1 1 10 5 20 Max. 4.5 5 6.5 Unit mV DVio Iio Iib Avd VOH V/oC 20 40 100 200 nA nA V/mV V 50 25 3.5 13.6 13.3 100 4.2 14.2 V 0.1 -14 0.15 -13.6 -13.3 mA 6 27 V VOL Isc Vicm dB dB A SR GBP m en THD VO1/VO2 3/5 MC33174 - 35174 PACKAGE MECHANICAL DATA 14 PINS - PLASTIC DIP Dimensions a1 B b b1 D E e e3 F i L Z Min. 0.51 1.39 Millimeters Typ. Max. 1.65 Min. 0.020 0.055 Inches Typ. Max. 0.065 0.5 0.25 20 8.5 2.54 15.24 7.1 5.1 3.3 1.27 2.54 0.050 0.020 0.010 0.787 0.335 0.100 0.600 0.280 0.201 0.130 0.100 DIP14.TBL 4/5 PM-DIP14.TBL MC33174 - MC35174 PACKAGE MECHANICAL DATA 14 PINS - PLASTIC MICROPACKAGE (SO) Dimensions A a1 a2 b b1 C c1 D E e e3 F G L M S Min. 0.1 0.35 0.19 Millimeters Typ. Max. 1.75 0.2 1.6 0.46 0.25 45 (typ.) o Min. 0.004 0.014 0.007 Inches Typ. Max. 0.069 0.008 0.063 0.018 0.010 0.5 8.55 5.8 1.27 7.62 3.8 4.6 0.5 4.0 5.3 1.27 0.68 8 (max.) o 0.020 8.75 6.2 0.336 0.228 0.050 0.300 0.150 0.181 0.020 0.157 0.208 0.050 0.027 0.334 0.244 Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of SGS-THOMSON Microelectronics. ORDER CODE : (c) 1997 SGS-THOMSON Microelectronics - Printed in Italy - All Rights Reserved SGS-THOMSON Microelectronics GROUP OF COMPANIES Australia - Brazil - Canada - China - France - Germany - Italy - Japan - Korea - Malaysia - Malta - Morocco The Netherlands - Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A. 5/5 SO14.TBL PM-DIP14.EPS |
Price & Availability of MC33174D
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |